FUNCTION BUTTONS
POWER SWITCH
USE & OPERATION
10
COOL
SPEED
SPEED
POWER
This unit is equipped with a spearate Main Power Switch,
located on the side near the top (part no.19). Please make
sure that this Power Switch is in the ON position, if your
Power Switch is not in the ON position the unit will not run.
Press the POWER button to turn the unit on. To turn the unit
off, press the button again. The cooler will start automatically
at medium speed. After a few seconds the speed will switch
to low.
COOL
To begin cooling the desired area press the COOL button.
The indicator light will come on and the water pump will
operate. You will feel the cooler air after the Honeycomb
Cooling Media is completely wet.
Press the SPEED button repeatedly and the speed will change.
The indicator light will show the selected speed.
High Medium Low
To Next Page
Loading...
Need help?
General
