Honeywell CL30XC Instruction Manual

CLEA
CLEANING THE HONEYCOMB FILTER
Turn o the unit, and unplug the power cord from wall outlet.
Rotate the unit facing the back panel, and locate the Rear Grill Removal Screws (refer page
7., No. 17). Remove both the screws with a screw driver.
Pull the rear grill panel upwards, untill it is completely removed.
Now, the Honeycomb lter can be seen. Clean the lter with clean cloth to remove all the dust
& dirt particles.
Once, the cleaning has been performed, assemble the unit back in the same fashion as
described above.
The appliance is supplied with a honeycomb cooling media lter.
Always keep the Honeycomb media clean. Wash the lter at least twice a year or as necessary.
Draining the water tank and relling it with fresh water atleast once a week will greatly reduce
mineral deposits in the pads and help extend the life of the honeycomb cooling media.
Do not run the unit in COOL mode with stale water in the tank.It is recommended to empty the
tank and rell it with freshwater, if the water has been standing inside the tank for an extended
period of time.
Cleaning frequency depends on local air and water conditions. For example, in areas where
mineral content of water is high, deposits may build up in the honeycomb cooling media,
restricting air ow. In this case, it is recommended to clean the honeycomb cooling media every
two months.
For best results, allow the honeycomb cooling media to dry after each use by turning o the cool
function 15 minutes before turning the unit o.
•
•
•
•
•
•
•
•
•
•
•
12

Honeywell CL30XC Specifications

General

Noise level	- dB
Product color	Silver
Package depth	395 mm
Package width	502 mm
Package height	885 mm
Package weight	13800 g

Weight and Dimensions

Depth	352 mm
Width	458 mm
Height	856 mm
Weight	11300 g