To Next Page

To Previous Page

CLEANING & MAINTENANCE

Draning and Cleaning The Water Tank

Cleaning the Honeycomb Cooling Media

•

Turn the power “off” and disconnect the air cooler from the power

supply.

Move the unit to a location where it can be drained.

Remove the drain plug and allow the tank to empty(refer page 8,

part 12).

Refill the water tank up to the maximum level with clean

water and drain it completely.

Fill water tank and rinse at least 2-3 times before use.

After cleaning ensure that the drain plug is back in place.

Plug into the power supply and turn on unit.

•

Turn off the unit, and unplug the power cord from wall outlet.

Rotate the unit facing the back panel, and locate the Rear Grill

Removal Screws (refer page 8, #15). Remove all the screws

with a screw driver.

Pull the rear grill panel, until it is completely removed.

The Honeycomb Cooling Media can now be seen. Clean the

carbon filter & honeycomb with clean cloth to remove all the

dust & dirt particles.

Once cleaning is finished, reassemble the unit as described

above.

Plug into the power supply and turn on unit.

The air cooler is now ready to be used. This cleaning process

should be repeated monthly to maintain the integrity of the unit

and to remove particles filtered from the air.

Water Drain

Plug

Open Screws

Honeywell CL48PM User Manual

Other manuals for Honeywell CL48PM