USE & OPERATION (CONTINUED)
3
CLEANING & DRAINING THE WATER TANK
Move the unit to a location where the water can be drained. Remove the cap from the Drain plug
located at the bottom of the unit. Allow the tank to empty.
Refill the water tank with clean water and drain it completely. Clean the water tank with dish detergent
or a damp cloth and rinse it thoroughly.
Refill the water tank with clean water, up to the maximum level.
Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive
elements or chemicals to clean this product.
When the product is not in use, store the unit in a dry place our of direct sunlight.
t
t
t
t
t
WARNING:
Before cleaning the unit, switch the unit OFF and disconnect from the power outlet.
Below are instructions on how to clean and maintain your air cooler. If the cooler will not be used for a
long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in the
separate Safety & Maintenance Guide.
Manual Water Tank Refill:
FILLING WITH WATER (CONTINUED)
When the connection is secured, turn ON the water supply and the water will flow into the water tank
of the cooler.
The cooler is now set so the water refills automatically when the water tank is empty, or when the
water reaches below a minimum level.
When the water tank is full of water, the water inlet valve will automatically stop the water supply from
overflowing the water tank.
WARNING: The maximum water inlet pressure is 0.5 MPa.
t
t
t
Open the Water Fill Door located on the side of the unit.
The Water Level Indicator is located at the side of the unit. Refill the water
tank when water level is low. Do not fill water above the "Max." water
level mark. Check the water level in the tank before running the COOL
function. Make sure that the water in the tank is above the minimum
water level mark. Running the unit in COOL mode with inadequate water
may cause pump failure.
Water Level
Indicator
Water Fill Door
LOW WATER ALARM
The unit is equipped with a low water sensor. In Cooling Mode, when water in the tank is below the
minimum level, you will hear a beeping sound and the will flash continuously. The unit will
automatically pause evaporative cooling.
Refill the water tank to deactivate the alarm in cooling mode. First switch OFF the unit and unplug from
the power outlet. Fill the water tank with water above the minimum water level mark. Plug in and switch
ON again.
To deactivate the alarm and continue using the unit as a fan (without evaporative cooling), switch the
unit OFF and then ON again. The Low Water Alarm will not activate in Fan only mode. The Low Water
Alarm will sound again if the COOL function is activated while the water tank is still empty.
To Next Page
Loading...
Need help?
General
