14
CLEANING & MAINTENANCE
Water Drain
Plug
Open Screws
Cleaning The Honeycomb Cooling Media
Draning and Cleaning The Water Tank
•
•
•
•
•
•
•
•
•
•
•
•
The air cooler is now ready to be used. This cleaning process should be repeated monthly to
maintain the integrity of the unit and to remove particles filtered from the air.
Turn the power “off” and disconnect the air cooler from the power supply.
Move the unit to a location where it can be drained.
Remove the drain plug and allow the tank to empty(#12 on Page 8).
Refill the water tank up to the maximum level with clean water and drain
it completely.
Fill water tank and rinse at least 2-3 times before use.
After cleaning ensure that the drain plug is back in place.
•
Plug into the power supply and turn on unit.
Turn off the unit, and unplug the power cord from wall
outlet.
Rotate the unit facing the back panel, and locate the Rear
Grill Removal Screws (#15 on Page 8). Remove the 4
screws with a screw driver.
Pull the rear grill panel, until it is completely
•
This cooler has Honeycomb cooling media on the right and
left panels. The cleaning and removal procedure is the same
as rear panel.
removed.
Plug into the power supply and turn on unit.
The Honeycomb cooling media can now be seen. Clean
honeycomb with clean cloth to remove all the dust &
dirt particles.
Once cleaning is finished, reassemble the unit.
To Next Page
Loading...
Need help?
General
