EasyManuals Logo

Honeywell CT3611 Installation Quick Guide

Honeywell CT3611
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
8
0
9
0
7
0
6
0
9
0
8
0
7
0
6
0
Model CT3611 Installation Quick Guide
Your NEW thermostat has a built-in program.
Items needed: pan head screwdriver, drill, and level (optional).
1. Turn off Heating/Cooling system power.
2. Remove old thermostat from wall. Use enclosed labels to mark the wires as you
disconnect them. Label wires using letters above screw terminals, not wire colors.
3. Separate wallplate from new thermostat. Mount wallplate to wall with hardware
provided. Use level, if desired, and 3/16 in. drill bit in drywall or 7/32 in. drill bit in
plaster or wood.
4. Attach the system wires to matching screw terminals, using the label designations from step
2. NOTE: If you have wires for both O and B, stop installation and consult Installation
Instructions.
5. Mount the thermostat to wallplate - insert top and snap in the bottom.
6. Set the thermostat System switch to Heat or Cool and the system will operate at
the factory programmed settings. See Programming Quick Guide (reverse) to
customize program.
Congratulations! You have finished installing your new Honeywell
programmable thermostat! For additional information refer to
Programming and Installation Instructions or www.honeywell.com/
yourhome.
R
W
Y
G
69-1556

Other manuals for Honeywell CT3611

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell CT3611 and is the answer not in the manual?

Honeywell CT3611 Specifications

General IconGeneral
BrandHoneywell
ModelCT3611
CategoryThermostat
LanguageEnglish

Related product manuals