Honeywell CW45 - Page 20

10 CW45 Mobile Computer User Guide
• For maximum battery life, charge the battery at 5°C (41 °F) to 40 °C (104 °F) and
store at 20 °C (68 °F) with a 40% charge.
• Do not store the battery pack at temperatures above 60 °C (140 °F). Storage
above 60 °C (140 °F) may damage the battery pack.
• Charge the battery before use. Battery ships with only a partial charge.
• See Charge the Battery Before Use on page 4 for approved charging methods.
Use of this battery in other devices could result in damage to the device or
battery.
• Avoid dropping the battery or computer. If you suspect that the battery or
computer is damaged, send it to a Honeywell service center for inspection.
• Replace the battery only with another CW45-BAT-S or CW45-BAT-EX model
battery that matches the part number noted in the Battery Part Numbers (see
page 4) section of this guide. These batteries have been tested in accordance
with applicable safety standards. Contact your Honeywell sales representative
or distributor if this battery is no longer available.
• Discarded batteries may create a safety hazard. Before disposal, cover the
battery contacts with electrical insulating tape.
• Do not modify the battery or attempt to insert foreign objects into it.
• Do not solder directly to the battery contacts.
• Do not drop the battery or apply mechanical shocks or pressure to it.
• Do not immerse batteries into, or expose them to water or seawater.
• Do not incinerate, microwave, throw into a fire, or expose batteries to
temperatures above the maximum rating.
• Do not disassemble a battery or try to open or penetrate its housing.
About the Mount and Arm Strap
For instructions on assembling the mount and arm strap, refer to the CW45 Quick
Start Guide available on the CW45 product page at sps.honeywell.com.
Power On the Computer
After you have fully charged and installed a battery, power on the computer for the
first time:
•Press and hold the Power button for approximately 3 seconds, then release the
button.