42 CW45 Mobile Computer User Guide
7. Check the box next to all the applications where you want the digital scan
button to be available.
8. Select OK.
9. Tap the Back arrow to return to the Settings screen.
The digital scan button appears on the screen when you open any of the apps
you selected during the button setup. Tap and hold the button to activate the
imager and scan a barcode.
Scan Barcodes
Before you start scanning barcodes, go into Settings > Honeywell Settings >
Scanning > Internal Scanner and modify the scan profile to enable only the
barcode symbologies that you need. By reducing the active symbology list, you can
increase scan speed.
1. Point the side-facing camera at the barcode. For
optimum performance, avoid reflections by
scanning the barcode at a slight angle.
2. Press and hold any assigned Scan button (see next
section).
3. Release the Scan button when the computer beeps,
and the Good Read LED briefly turns on. The
barcode information is entered into the application
in use.
Note: Not all barcode symbologies are enabled by default. If a barcode does not scan, the
correct symbology may not be enabled.
Scan Buttons
Out of the box, the F3 button has been remapped to Scan so that you can use a
configuration barcode during setup. Once that remapping is cleared, the F3 button
returns to its default of Enter (see page 23).
To remap another key for use as a Scan button, see page 23.
To use the digital scan button, see page 41.
To Next Page
Loading...
