CW45 Mobile Computer User Guide 43
About Scanning Configuration Barcodes
After completing the out-of-box set up process, Provisioning mode is
automatically turned off. Scanning a barcode to install applications, certificates,
configuration files, and licenses on the computer is restricted unless you enable
Provisioning mode in the Settings app.
To learn more About Provisioning Mode, see page 71.
Use the Scan Demo App
Use the Scan Demo app to read barcodes or to test your symbology decode
settings.
1. Swipe up from the bottom of the Home screen to
access all apps.
2. Tap the Demos app.
3. Swipe left or right on the screen until Scan Demo
appears under the turntable. Tap the center of the
box image to open the app.
4. Touch Scan on the computer screen.
Barcode information appears on the screen.
Note: In the Scan Demo app, not all barcode symbologies are enabled by default. If a
barcode does not scan, the correct symbology may not be enabled.
Change the Scan Demo Symbology Settings
1. In the Scan Demo app, tap in the upper right corner of the screen.
2. Select Symbology Settings.
3. Modify the symbology parameters.
• Tap the check box next to a symbology name to enable (check mark) or
disable (no check mark) decoding for that symbology.
• Tap the symbology name to view and modify additional configuration
parameters for the symbology selected.
4. Tap the Back arrow to return to the Scan Demo app.
To Next Page
Loading...
