CW45 Mobile Computer User Guide 69
For a complete list of compatible accessories for your mobile computer and their
part numbers see the CW45 Accessory Guide available for download at
sps.honeywell.com.
Contact your local sales representative for ordering information.
USB Troubleshooting
• If you have a problem with your workstation computer recognizing the USB
device, try downloading and installing the Honeywell-aidc-usb-driver. The
driver is part of the Honeywell_Mobility SDK_Android software.zip file. To learn
where to get the software, see Developer Information on page 71.
• Check to make sure you have enabled the USB for file transfer. To learn more, see
Configure USB Connection and Transfer Files on page 18.
USB or Bluetooth Tethering for Data Connection Sharing
You can share your mobile computer data connection with another device through
a USB tethering or Bluetooth tethering connection.
Minimum requirements for USB Tethering
• Mobile computer minimum operating system version of Android 9 or later.
• A compatible USB communication accessory and/or cable.
Set Up and Connection
1. Connect the devices using a USB accessories and/or cable.
2. On the CW45, change the USB Preference settings from USB Charging to
USB tethering. To learn more, see Configure USB Connection and Transfer
Files on page 18.
3. Tap Settings > Network & internet > Advanced> Hotspot & tethering.
4. Select USB tethering to initiate the shared data connection.
Note: To stop sharing the connection, tap USB tethering again to turn Off the feature or
disconnect the USB accessory.
Minimum requirements for Bluetooth Tethering
All devices must support Bluetooth communication.
To Next Page
Loading...
