Honeywell Dolphin 75e Power Up Instructions

75E-AND-ENUS-IG Rev B, 5/15
Power Up Instructions
Follow the steps below the first time you power up the terminal.
1. Install the battery.
2. Charge the battery for 6 hours.
3. Press the Power button. When the Honeywell logo appears and the right green LED turns on,
press and hold both the Volume Up and Home buttons at the same time. 

If the terminal shuts down, repeat step 3.
4. Release the buttons when the green LED turns Off. After approximately 30 seconds, the
system update screen appears. When the system update is finished, the lock screen appears.
For more information on how to use the Dolphin 75e, see the enclosed Quick Start Guide.
Power
(top)
Volume Up
(side)
Do not remove battery during update!
75E-AND-ENUS-IG Rev B.fm Page 1 Tuesday, May 19, 2015 6:18 PM

Honeywell Dolphin 75e Specifications

General

Display diagonal	4.3 \
Display resolution	480 x 800 pixels
Speakers	stereo
Flash memory	16 GB
Internal memory	0.002 GB
Internal memory type	-
Compatible memory cards	MicroSD (TransFlash), MicroSDHC
Processor family	Qualcomm
Processor frequency	2.26 GHz
Bundled software	Honeywell Powertools and Demos
Operating system installed	Android 4.4.4
Data network	Not supported
Wi-Fi standards	802.11a, Wi-Fi 5 (802.11ac), 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Bluetooth version	4.0
Security algorithms	EAP-TLS, EAP-TTLS, WEP, WPA2-PSK
Rear camera resolution (numeric)	8 MP
I/O ports	Micro USB, headphone/mic combo jack
Headphone connectivity	3.5 mm
Product color	Black, Orange, Silver
Phone function	No
International Protection (IP) code	IP67
Battery capacity	1670 mAh
Battery life (max)	6 h
Storage temperature (T-T)	-25 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Operating relative humidity (H-H)	0 - 95 %

Weight and Dimensions

Depth	134 mm
Width	73 mm
Height	18 mm
Weight	204 g