6
Install the Main Battery Pack
The 99EX/99GX is shipped with the battery packaged
separate from the terminal. Follow the steps below to
install the main battery. For information on how to remove
the battery, see page 6.
Ensure all components are dry prior to placing the battery
in the terminal. Mating wet components may cause
damage not covered by the warranty.
1. Release the hook securing the hand strap to the back
panel of the terminal (99EX only).
2. Remove the battery door by lifting up the latches near
the base of the battery door.
3. Insert the battery into the battery well.
4. Replace the battery door. Apply pressure to engage
the door latch. The battery door must be installed
prior to powering the unit.
5. Reattach the hand strap (99EX only).
6. Connect the terminal to one of the 99EX series
charging peripherals to charge the main battery pack.
We recommend use of Honeywell Li-poly or Li-ion
battery packs. Use of any non-Honeywell battery may
result in damage not covered by the warranty.
To Next Page
Loading...
Need help?
General