Chapter 1: Product Features of ScanPal50 Series EDA50K-X Terminal
16
User Guide for ScanPal50 Series Terminal
Store the battery outside
the terminal
Put the battery in the charger.
Battery maintenance recommendations and safety protection measures
• Fully charge the battery before using it. The battery is only partly charged when get
packed.
• Refer to the chapter "charging" to get the right process for battery charging. Using the
battery for other devices may cause damages on the device or the battery.
• Avoid battery or terminal drops. If you suspect that a battery or terminal fails, send it
to Honeywell service center for verification.
• This battery can only replace another BAT-EDA50K-X battery. These batteries have
been tested and meet the appropriate safety standards. If you need to replace the
battery, please contact Honeywell service representatives or the resellers.
• There are security risks in waste batteries. Before cleaning up the battery, stick the
poles with insulation tape.
• Do not modify the battery or attempt to insert foreign objects into the battery.
• Do not solder directly to the battery poles.
• Do not short connect the battery and put the battery away from metal objects.
• Do not drop or mechanically shock or extrude the battery.
• Do not disassemble or open the battery. Do not crush, bend or deform the battery; Do
not puncture, shred or burn the battery.
• Do not immerse the battery in water.
Enabling Airplane mode
If you don't need to connect to any wireless network, you can enable the airplane mode to
turn off all wireless receivers to save power.
1. Tap Settings.
2. Tap More under Wireless & Networks.
3. Open Switch control of Airplane Mode to enable airplane mode.
To Next Page
Loading...
Need help?
General