Honeywell EGPWS MK VII - Page 56

Mark V and Mark VII EGPWS Pilot’s Guide
Operational Procedure 060-4241-000
50 Rev H, August 2011
Level 1
Self-Test
Continued
When a Self-Test is initiated, the EGPWC first checks for any
configuration (installation or database) errors. If any are
detected it is audibly enunciated and the test is terminated. If
none detected, the test continues through a sequence resulting
in turning on and off all system annunciators, enunciating
specific audio messages, and if enabled, displaying a video
test pattern on the terrain display (see illustration below). Any
functions determined inoperative are also enunciated (e.g.,
“GLIDESLOPE INOP”). The Self-
Test terminates
automatically at its conclusion.
The following is a description of the expected results of a
typical Level 1 Self-Test. Actual annunciation nomenclature
and sequence may differ depending on the installation.
• GPWS INOP, W/S INOP, and TERR INOP annunciators
turn on.
• Amber caution (“BELOW G/S” or “GPWS”) annunciators
turn on.
• “GLIDESLOPE” is announced over speaker.
• Amber annunciators turn off.
• G/S CANCEL annunciators turn on (if installed).
• G/S CANCEL annunciators turn off.
• Red warning (“PULL UP” or “GPWS”) annunciators turn
on.
• “PULL UP” is announced over speaker.
• Red warning annunciators turn off.
• Red Windshear warning annunciators turn on.
• (Siren) “WINDSHEAR, WINDSHEAR, WINDSHEAR” is
announced over speaker.
• Red Windshear warning annunciators turn off.
• Amber Windshear caution annunciators turn on (if installed
and enabled).
• Amber Windshear caution annunciators turn off.
• Red warning (“PULL UP” or “GPWS”) Terrain Awareness
annunciators turn on.
• “TERRAIN, TERRAIN, PULL UP” is announced over
speaker.
• Red warning Terrain Awareness annunciators turn off.
• Amber alert Terrain Awareness annunciators momentarily
turn on, then off.