STEP 1
Put the cell(s) on the lower rack of the dishwasher with the airflow arrow
pointing up. It may be necessary to remove the upper rack. Don’t block
water flow to the upper arm, if provided on your dishwasher. If you are
washing the prefilter(s) with the cell(s), place them where they won’t
block the water flow to the electronic cell(s).
HINT: Lay a few large water tumblers between the “spikes” on the lower
rack, and rest the cell(s) on them so the “spikes” don’t damage the
aluminum collector blades.
STEP 2
Using the detergent that works best for normal dishwashing, allow the
dishwasher to run through the complete wash and rinse cycle. Do not
use the dry cycle. To avoid burns, let the cell(s) cool completely before
removing, or wear protective gloves when removing the cell(s). Remem-
ber that water may be trapped inside the cell(s) plates. Tip the cell(s) to
drain.
STEP 3
Wipe the ionizer wires and red contact board on end of cell with a clean
cloth.
STEP 4
Inspect the dishwasher. You may wish to rerun the wash and/or rinse
cycle with the dishwasher empty if you see dirt or residue from washing
the cell(s). If dirt or residue seems excessive, wash the cell(s) more
often or try a different detergent.
69-0376—4 10
To Next Page
Loading...
Need help?
General
