11 69-0376—4
Washing the
cell(s) in a tub
NOTE: Always wash the cell(s) first, then the prefilter(s) to keep heavy
lint on the prefilter from getting caught in the cell(s).
STEP 1
Use a large enough container such as a laundry tub or trash container,
to hold one or both cell(s).
NOTE: Sharp corners on the cell(s) can scratch the surface of a
bathtub.
STEP 2
Dissolve about 3/4 cup of automatic dishwasher detergent per cell in
enough hot water to cover the cell(s). If the detergent doesn’t dissolve
readily, or forms a scum on the water, try another brand, or use sof-
tened water.
STEP 3
After the detergent is completely dissolved, place the cell(s) in the
container and let it soak for 15 to 20 minutes. Agitate cells up and down
a few times and remove.
STEP 4
Next, wash the prefilter(s) the same way. Empty and rinse the wash
container.
STEP 5
Rinse the cell(s) and prefilter(s) with a hard spray of very hot water;
rinse the tub clean, then fill the tub with clean hot water and soak for 5
to 15 minutes. Rinse until the water draining from the cell(s) and
prefilter(s) no longer feels slippery.
STEP 6
Wipe the ionizer wires and red contact board on the end of the cell with
a clean cloth.
CAUTION
Hazardous chemical.
Can cause personal injury.
• Do not splash the detergent solution in eyes.
Wear rubber gloves to avoid prolonged de-
tergent contact with skin.
• Keep detergent and solution out of reach of
children.
To Next Page
Loading...
Need help?
General
