FocusPRO
®
6000 Series
Installation
Instructions
Programmable
Digital
Thermostat
Wallplate installation
Remove the wallplate from the thermostat,
then follow directions below for mounting.
1. Remove battery holder.
2. Pull here to remove wallplate from new
thermostat.
3. Pull wires through wire hole.
4. Position wallplate on wall, level and mark
hole positions with pencil.
5. Drill holes at marked positions as shown
below, then tap in supplied wall anchors.
6. Place wallplate over anchors, insert and
tighten mounting screws.
7. Insert reference card.
Drill 7/32"
holes for
plaster.
Drill 3/16"
holes for
drywall.
Wire hole
Mounting
screws
To Next Page
