How to pre-assemble the parallel bracket
The parallel bracket may be pre-assembled as illustrated by steps j to m.
How to install a Parallel Bracket and fit a Beam sensor
The installation of the parallel bracket and beam sensor are illustrated by steps j to q.
Further information about this product can be found in Part 2
of this document available on Gent Expert website.
Data and Installation S4 Beam Sensor & brackets
Gent by Honeywell reserves the right to revise this publication from time to time and make changes to the content hereof without
obligation to notify any person of such revisions of changes.
Hamilton Industrial Park, Waterside Road, Leicester LE5 1TN, UK Website: www.gent.co.uk
Telephone: +44 (0) 116 246 2000 Tech. Support: www.gentexpert.co.uk Fax (UK): +44 (0)116 246 2300
4 4188-969 issue 3_Part 1_07-11_S4 Beam & brackets
At the end of their useful life, the packaging,
product and batteries should be disposed of
via a suitable recycling centre and in
accordance with national or local legislation.
Do not dispose of with your normal household waste.
Do not burn.
WEEE Directive:
At the end of their useful life, the packaging,
product and batteries should be
disposed of via a suitable recycling centre.
0832
Gent by Honeywell
Hamilton Industrial Park,
140 Waterside Road,
Leicester LE5 1TN, UK
Product EC Certification
No. of Conformity No.
S4-34741 0832-CPD-1365
S4-34742 0832-CPD-1365
ARROW
Fixed plate
Adjustable plate
Adjuster
Bush
Lock nut
Bush
Spring
8mm
8mm
Ensure the adjusters are set to provide an 8mm
gap all around between the adjustable and fixed plates.
THIS WAY UP
Pre-assembled
Parallel bracket
Metal
box
Beam Sensor
Base
EM2
OUT5
IN4
C3
L1
0V
L2
LOOP IN
LOOP OUT
Loop Cable
In - Out
Test Keyswitch wiring if used
The Test Keyswitch
connects to EM2 and
C3, see page 3.
Sleeve
Ensure the base is mounted to the bracket such
that the Beam sensor LEDs can be seen from floor level.
To Next Page
Loading...
