Performance Series Network Video Recorder User Guide
88
Figure 8-11 Network Abnormality Configuration Tab
2. On the Network tab, in the Event Type box, select the event type for which you want to
configure settings: Disconnect, IP Conflict, MAC Conflict.
3. Select the Enable check box to enable network error detection for the selected event type.
4. Select the actions that you want the system to initiate when the selected event occurs:
Alarm Out: Select the check box to activate the selected alarm output(s) (1 or 2). In the
Latch box, specify the amount of time (0–300 s) to delay the alarm output signal after the
network event is triggered.
Show Message: Select the check box to enable a pop-up message on your local host PC.
Send Email: Select the check box to enable the system to send an email notification. To
set up Email settings, see Configuring Email Settings on page 68.
Voice Prompts: Select the check box to enable the playing of a voice prompt audio file
when a network event is triggered. Use the File Name drop-down arrow to select the audio
file to play for network events.
Buzzer: Select the check box to activate a buzzer noise at the NVR.
Log: Select the check box to enable logging of network events.
5. Click Apply to save your settings.
Configuring Username Settings
1. Go to Main Menu SETTING EVENT ABNORMALITY Username.
To Next Page
Loading...