Honeywell HEN16103L - Getting Started with Your NVR; Unpacking and Connecting Devices

Getting Started
11
2 Getting Started
This chapter contains the following sections:
• Unpacking the NVR on page 11.
• Connecting External Devices on page 11.
• Starting and Shutting Down the NVR on page 16.
• Device Initialization on page 17.
• Reset Password on page 19.
• Setting Up the NVR with the Startup Wizard on page 21.
• Setting Up Bi-Directional Communication Connection on page 24.
Unpacking the NVR
Before you set up the NVR, make sure that you have received the following items:
• Quick Installation Guide • Remote control
• Quick Networking Guide • CAT5e network cable
• Software CD • Terminal block connectors (×2)
• Power adapter and cable • Screws (×10)
• Mouse • Serial ATA (SATA) cable*
If any of the items listed above are missing or damaged, contact your Honeywell dealer
immediately.
Connecting External Devices
Step 1: Connect the cameras
Connect the coaxial cables from the cameras to the VIDEO IN connectors (1 Vp-p, 75 ohm).
Step 2: Connect the monitor
Connect a VGA cable (not supplied) to the VGA interface and/or an HDMI cable (not supplied)
to the HDMI interface. Connect the other end to a monitor (do not use a TV). Simultaneous
VGA and HDMI output is supported.
Step 3: Connect the mouse
Connect the supplied USB mouse to the USB 2.0 interface.