Performance Series Network Video Recorder User Guide
120
Figure 10-5 Display Configuration Tab
2. On the Display tab, configure the following settings:
Transparency: Set the transparency of the graphical user interface (GUI) to a value
between 0 and 100, with 0 being totally opaque and 100 being totally transparent.
Time Display: To display the current time in each channel window in live view mode, select
the check box. To hide the time, clear the check box.
Channel Display: To display the camera name, status, and channel number in each
channel window, select the check box. To hide the camera name, status, and channel
number, clear the check box.
Image Enhance: To enhance the display image, select the check box. To keep the default
settings, clear the check box.
Analytics Rule: To display the active analytics rule in each channel window in live view
mode, select the check box. To hide the analytics rule info, clear the check box.
Original Scale: Click Setup to select the channel(s) to display in the original aspect ratio,
then click OK. Select All to display all the channels in the original aspect ratio. Unselected
channels display in full screen.
Resolution: Set the resolution of your display select in the Screen NO field.
Note
You must restart the NVR for new display resolution settings to
take effect.
Preview Mode: Select the Preview Mode from the drop-down list from Regular or Show
Face List.
Video Spot: Check to select VGA Output or HDMI Output. In the selected output, the user
operation is disabled and it only displays the playback.
3. Click Apply to save your settings.
4. If you want to save your settings and exit the SETTING menu, click OK.
To Next Page
Loading...