7
Condensation may accumulate in the unit.
If the bottom internal tank is full, the WATER FULL light will illuminate and an alarm will beep for 30
seconds. The unit will not operate until the water has been drained from the bottom drain plug (refer
to Water Condensation Drainage).
After switching the air conditioner off, the compressor will not start immediately.
You must wait about 4 minutes before it switches back on again.
WATER FULL LIGHT
Sleep Mode
When the Sleep Mode is activated in Air Conditioning mode, the set temperature will increase
by 1°F or 1°C after the first hour of cooling and will increase a further 1°F or 1°C after the
second hour of cooling. The unit will maintain this temperature for 5 hours. The set
temperature will then reduce by 1°F or 1°C on the seventh hour and reduce a further 1°F or
1°C on the tenth hour. Sleep mode will then deactivate automatically.
In Heating Mode*, the set temperature will reduce by 2°F or 2°C after the first hour of heating
and will reduce a further 2°F or 2°C after the second hour of heating. The unit maintains
heating at this temperature for 5 hours. Then, the set temperature will increase 2°F or 2°C
at the seventh hour and will increase a further 2°F or 2°C on the tenth hour. Sleep mode will
then deactivate automatically.
Note: The Sleep Mode can be deactivated during cooling or heating mode by pressing any
button at any time.
•
USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
EN
*Applicable for models with Heating feature only.
To Next Page
Loading...
Need help?
General
