4
To Wire the Panel with the Communicator
Panel’s Terminal
Panel’s
Connector
Connections at CLSS Pathway
AUX
+
Connect to +
GND
-
Connect to -
Primary Dialer
RING Connect to RING
TIP Connect to TIP
Backup Dialer
RING2 Connect to RING2
TIP2 Connect to TIP2
CAUTION
DO NOT USE RESETTABLE POWER TERMINALS.
Powering ON
01. Power ON the communicator and the panel.
02. Ensure that the panel and the communicator are receiving power.
03. Ensure that the Green LED on the communicator is continuously ON indicating successful connections.
NOTE
: Refer to the
Troubleshooting
section if there is an issue to resolve.
Figure 2: Wiring for Dialer Capture
To Next Page
Loading...
