INSTALLATION GUIDELINES
DO NOT use an extension cord with this unit. If the power cord is too short,
have a qualified electrician or service technician install an outlet near the
appliance.
Remove the exterior and interior packing.
With both hands, one under the front panel between the faucets and the
other in the handle located in the back, move the unit and place it in the
desired location, provided it is a leveled surface.
ATTENTION: If you do not plan to use the water heating function for more than
three days, we recommend that you turn off the hot water power switch.
EN 6
freezing (32
0
F / 0
0
C).
This unit is for indoor use only and must be installed in a cool, ventilated area.
Place the unit on a level surface that is strong enough to support the
dispenser.
DO NOT cut or remove the third (ground) prong from the power cord under
any circumstances. Any questions concerning power and/or grounding
should be directed toward a certified electrician.
Plug the unit into an exclusive properly installed grounded wall outlet.
Make sure the hot and cold water power switches are in the OFF position
before plugging the unit into the power source.
Please follow the instructions to load the water bottle before plugging the
unit into a power source.
DO NOT locate the unit in areas where the temperature may fall below
Direct sunlight may also cause algae to grow inside your water bottle which
may later cause product malfunction.
Direct sunlight may affect the unit over time and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause
the appliance not to perform properly.
Locate the unit away from direct sunlight and sources of heat (stove, heater,
radiator, etc.).
Keep the area around the unit free of dust and dirt.
BEFORE CONNECTING THE UNIT TO THE POWER SOURCE, let it stand up
for uprights for approximately 24 hours. This will reduce the possibility of a
malfunction in the cooling system from mishandling during delivery.
Allow 6 inches of space between the unit and the wall.
DO NOT use an adapter plug with this unit.
To Next Page
Loading...
Need help?
General
