Honeywell KaltecSoft KS30E Series User Manual

GB
Honeywell GmbH 14 MU0H-1420 GE23 R0618
If the home position is not detected within 10 minutes,
the main display will show an "Err 1" message to
indicate a controller error and an audible alarm will
sound. The error condition can only be cleared by
removing and re-applying the power.
CAUTION!
If problem persists, please call your local dealer or
after sales service team.
7Dimensions
Note: All dimensions in mm unless stated otherwise.
Checklist Solution Page
Problem: Water runs from the drain constantly.
Is the unit in recharge mode? If yes, this is normal, wait until the recharge is complete. 5
Is the power on? There should be no flow to drain in the service position. 6
Problem: Excessive salt usage.
Check the hardness setting. Reduce the hardness if incorrect. 5, 12
Problem: Electronic Display.
The display shows error code: "Err 1", audible alarm
sounds, (see note below).
Check all the connections are secure. Turn the power off
for 10 seconds then turn back on, allow the system to
reset.
11
Is the digital display blank? Check the power is turned on and all the connections
are secure.
Problem: Unit regenerates at the wrong time.
Is the present time correct? Reset the present time. 5
Overview

Honeywell KaltecSoft KS30E Series Specifications

General

Brand	Honeywell
Model	KaltecSoft KS30E Series
Category	Water Dispenser
Language	English