Honeywell KaltecSoft KS30E Series User Manual

GB
Honeywell GmbH 4 MU0H-1420 GE23 R0618
1.5 Scope of Delivery
2 Quick Operation
2.1 Display and control elements
Note: In the programming mode the respective >target value<
flash.
2.2 Standard settings
On first powering up the softener the digits of the display will
flash while the valve rotates to service position.
The valve can be heard moving and this can take a few
minutes. On locating service position the display will prompt
the installer to set the time.
Go to section 2.3 Programming procedure to set the time and
hardness settings.
Overview Honeywell water softer with:
Standard delivery
1 Access cover
2 Multi-way control valve with microprocessor controller
3 Salt storage container
4 Softened water outlet
5 Hard water inlet
6 Drain water
7 Blending valve
8 Overflow connection
9 Softening column with ion exchange resin
(inside the salt storage container)
10 Multi-Block Connector BSP: ¾” (DN: 20/20)
11 2 x Connection Hose
12 2 m drain water hose (flexible)
13 Hose clamp connection
14 Mains plug power supply connection
Please open the access cover (1) see 3.2
Initial commissioning
A. Salt storage container
B. Brine cabinet
C. Fixing material see chapter 3.2 Initial commissioning
D. Rating plate and serial number see chapter 3.2 Initial
commissioning
Not depicted components:
Water hardness tester
10
11
12
13
2
1
3
1
4
5
6
7
8
9
14
The display shows:
the current time
the remaining capacity in 20%
bars
[UP] [DOWN] [SET/
RETURN]
[RECHARGE]
= Moves cursor changes
entries
= Confirms
entries
= Programming
recharge
tonight

Honeywell KaltecSoft KS30E Series Specifications

General

Brand	Honeywell
Model	KaltecSoft KS30E Series
Category	Water Dispenser
Language	English