Installing Detectors & Sirens
Note: After correctly installing a device you will hear short beeps from the Badge reader or
the keypad
Door contact
Please refer to the printed manual supplied with the product for full guidance.
Install the contact:
Inside the room to be protected
Opposite the hinges for faster opening detection
Attach the magnet to the opening part, for example the door and not the frame
Attach the sensor to the door frame and not the door
With the magnet opposite the mark shown on the detector
With less than 2 cm between the magnet and the detector when the door/window
closed
So that opening the door or window fully does not damage the magnet
Do not install the contact:
Outdoors
Near a water point (e.g. bathroom)
Motion detectors
Please refer to the printed manual supplied with the product for full guidance.
Install the detector:
In a circulation area, preferably pointing towards entrances (e.g. door, window)
Preferably in a corner to optimize the detection area
In a place where animals cannot get within a distance of 1.80 m by climbing on
furniture, stairs, boxes or any other object
In a detection area free of obstacles (e.g. curtains, wardrobes)
At a height of between 2.30 m and 2.50 m above the ground
Do not install the detector:
In a room smaller than the detection area (at least 4 m²)
To Next Page
Loading...
