Honeywell LYNX Touch L5200 Series - Remote Phone Control Feature

 





' .)   
!  H<(I !    E&     )          
    B  B   *   & !    )&  
)*&*&&*  ) 
 8(+( 
! *& B ?
• % 
•  !<9<&
• 3A
• " 
! &?
• 
• &
• 7"&& * :;&:&* CP;
• (&&&#&&  & 
@ )0& #&
'*?
• 
• ! !&
• 4 &&:*&;
Using Remote Phone Control Feature
% = '* @ #&#2
*@ &&*     *&    &  &  C<!.+
.(!.8"%.D'*  @&& & * 
 * 9  ) :;& :   11 &; & &     
*! &&C<!.+D
Remote Phone Control Commands
Enter User Code (within eight seconds). Upon entering remote phone control mode the Lynx will announce “System, enter code”.
To remotely disarm system: ..................................................................... User Code + [1]
To remotely arm in AWAY mode: ............................................................. User Code + [2]
To remotely arm in STAY mode: ............................................................. User Code + [3]
To remotely arm in AWAY or STAY mode with no delay: ......................... User Code + [2] or [3] + [0]
To remotely Bypass zones: ..................................................................... User Code + [6] + zone no.
To remotely activate Force Bypass: ........................................................ User Code + [6] + [#]
To remotely check system status: ............................................................ [✻]
To end remote phone session: Hang Up or ............................................ User Code + [9]
Notes: (1) Check with your installer to see if the Force Bypass mode has been enabled.
(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been bypassed.
