Honeywell LYNX Touch L5200 Series - Testing the System

 





,)&'4 (" "$#&6
Test Modes
! !)& 9!@%!@"!&8! 
9!&  &9  9!&
)@ &*),$&&   !&! 
% !         & !  " !        9
&/+! 8 E&

NOTE: An alarm message will not be sent to your alarm monitoring company during these tests.

Entering Test Mode
% &&&@&@! C8&D& &

Testing or Rebooting the System
Arm Away
Ready To Arm
Arm Stay
BackDelay
Settings
10:18 AM June 8, 2010
5200-100-033-V0
Tools
1. With the system in the disarmed state, select the “Tools” icon
from the second page of the Security Screen. The system
displays the Keypad screen.
Ready To Arm
Program the system
Enter Code:
Cancel
5200-100-035-V0
231
5
64
0
8
97
Clear
2. Enter your 4-digit Master User Code. The system displays the
Master User programming screen.
WiFi ConfigDate Time
Ready To Arm
Events
Back
Reminders
KeypadUsers
5200-100-036-V0
Slide Show
Test
3. Select the “Test” icon. The system displays the Test screen.