,)&'4 (" "$#&6
Ready To Arm
Back
Prod. Id. : XXXX Sw. Rev.: XX.XX
CRC Number: XXXX
RF Version Number: XXXXXX
WiFi Ver: X.X.X
Walk Test
Dialer Test Comm. Test Reboot
5200-100-087-V0
4. Select the “Walk Test”, “Dialer Test”, “Comm. Test” or
“Reboot” icon. If Walk Test is selected proceed to Step 5. If
Dialer Test is selected proceed to Step 6. If Comm. Test is
selected proceed to Step 7. If Reboot is selected proceed to
Step 8.
5. “Walk Test…” is displayed on the system status bar and the
control sounds a single beep every 30 seconds. Fault each
zone as described below.
6. If the dialer test is unsuccessful after 8 attempts, the system
will display a Reporter Failure message. Contact your security
service provider.
7. The system will advance to the Communications Test Screen.
Refer to the Communications Test paragraph.
8. The system will reboot itself.
9. After the reboot sequence is completed, conduct a Walk Test
to verify that all transmitters are operational in the system.
Walk Test
?> &&&&& @
& A= %@ *& '& &
& &! & &&&
9 & :&; & &/ )&@
*&! & & & & )&@&)
& & :*&;! & && (
& &@ & ) @ ,B &
)
!&@ F! & & &
& )&
'0& :*&@&;@)
9 ) && :&;@ & A &
&&
Test Communications
%&* " &) & *
&& &&& "
• Test Ethernet
' @ &?Service OK
• Send Any
• Send GSM Message
• Send Ethernet Message
' @ &?Test Message Sent
' @ &?Test Message Failed – Not Registered!
Exiting Test Mode
9 *&@0 9!"!&* J&*
+7"&:E&;
NOTE: If the Walk Test mode is inadvertently left active, it automatically turns off after 4 hours.
'.+2
! H<(I ! & ) & " * & 0* !
&
To Next Page
Loading...
Need help?
General
