Press to program “WAKE” time and press to program “WAKE” temperature for
Mon-Fri. Repeat sequence for “LEAVE,” “RETURN,” “SLEEP.”
Schedule
This guide can be used for programming your new thermostat.
NOTE: Batteries are required for operation and programming. When inserting batteries, set
system switch to OFF. Remove battery door (on thermostat left side) using a coin at the
bottom. Follow instructions on pages 6 and 7.
Set Current Time/Day
12
To set time, press and release once, press until current time shows; to set day,
press and release again, press until current day shows; then press .
Heating Program
With system switch at HEAT, press and release once. “WAKE,” Mon-Fri and “SET”
appear on display.
Clock/Day
Clock/Day
Schedule
13
PROGRAMMING
Run
Program
Time
Time
Time
Temp
Time
Temp
Cooling Program
With system switch at COOL, follow same instructions as for Heating Program.
After programming, adjust fan and system switches as desired. Press and release to
start the program.
Press until “WAKE,” “SA SU” and “SET” appear on display. Press to program
“WAKE” time and press to program “WAKE” temperature for Sat-Sun. Repeat sequence
for “SLEEP.”
Run
Program
To Next Page
Loading...
Need help?
General
