Temporarily Change temperature for current period only, press ; temporary indicator will
show on display but will cancel itself at next scheduled change; to cancel sooner, press .
Hold a temperature indefinitely, press , ; to cancel, press .
A quick guide for operating or making changes follows:
NOTE: System switch must be set to Heat or Cool to perform the following:
Run
Program
14
Check Current Temperature Setting, press . (If using Temporary Change or Hold,
pressing this will cancel your change.)
Check Programs, press repeatedly to see each time and temperature; then press .
Cancel a program, press until program to cancel shows; then press together.
Permanently Change a program, repeat steps under Heating Program or Cooling Program
(pages 12 and 13) as applicable.
Return to normal program or start program, press .
Questions?
Call Honeywell
Customer Assistance
1-800-468-1502.
PROGRAMMING
15
Temp
Hold
Temp
Temp
Run
Program
Run
Program
Schedule
Run
Program
Schedule
Time
Run
Program
To Next Page
Loading...
