ENS5001R2 KO06 2005
1
MCV2000 SERIES
2-WAY HYDRONIC VALVES
PRODUCT SPECIFICATION SHEET
The MCV2000 series are designed for residential
hydronic heating and cooling control applications.
The MCV2000 series 2-position hydronic valves are
used in residential and small commercial applications
to control the flow of hot and/or cold water. They
consist of actuator and valve.
Control by a low or line voltage SPST or SPDT
controller
100~130 VAC or 200~240VAC actuators available
Minimal actuator power consumption
Pressure differential up to 3.5bar
Versatile valve(1/2” ~ 1 1/4”) selection
1~90 °C fluid temperature
0~65 °C ambient temperature
Contents
………………………………………………… 1
Features …………………………………………………… 1
Specification ……………………………………………... 1~3
Dimensions ………………………………………………… 3
Installation …………………………………………………. 4
Wiring Diagram ……………………………………………… 4
Pipe connection : PT
Maximum pressure : 10bar max.
Electrical termination : with integral 1000mm lead-wire cable
Ambient Temperature : 0 ~ 65 °C
Ambient Humidity : 10 ~ 95%RH (no condensing)
Storage temperature : -25 ~ 65 °C
Storage Humidity : 10 ~ 95%RH (no condensing)
Voltage : AC110/220V±10%, 50/60Hz
Colour-coded
label
: Green, Black, White
Control
Performance
: SPST/SPDT control
Power
consumption
: 6W at nominal voltages
(during valve position change only)
Operational life
: Greater than 60,000 cycles (all loads) for
motor and valve contacts at 110/220V
Timing : 7.5sec (20sec in case 1 1/4” valve)
To Next Page
Need help?
General
