7
USE & OPERATION (CONTINUED)
EN
FUNCTION BUTTONS (CONTINUED)
Condensation may accumulate in the unit.
If the internal tank becomes full, the Power Control light will flash and the unit will not operate until
the unit has been drained (refer to Water Condensation Drainage).
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
WARNING LIGHT
For air circulation without air conditioner cooling.
FAN SPEED CONTROL
While the unit is turned on, press the timer button then press the
▼
or
▲
to select the number of
hours you would like the unit to continue to run. The unit will turn off automatically.
AUTO TURN OFF:
While unit is running, press the
▼
or
▲
button to select the number of hours you want the unit to run
in air conditioning mode.
AUTO TURN ON:
When unit is in a standby mode (plugged in with power light on), then press the
▼
or
▲
button to
select the number of hours until you want the unit to automatically start running.
TIMER CONTROL
TEMPERATURE / TIMER SET CONTROLS
Used for adjusting the timer and thermostat.
The default display is setting temperature.
In cooling mode, when
▼
or
▲
button is pressed, the set temperature is displayed and may be
adjusted. After 10 seconds the display will revert back to room temperature. Temperature is only
adjustable in cool mode. The time is adjustable between 1 - 24 hours.
Note: By pressing both
▼
or
▲
buttons at the same time, the display will toggle between
Celsius(°C) and Fahrenheit(°F).
•
•
•
When heating mode* is selected the indicator light will shine. Heating is activated only when
the ambient temperature is below 25°C (77°F). In this mode, the desired temperature can be
set between 16°C 25°C (61°F 77°F).
Note: The exhaust hoses must vent outside the room when using heating mode.
IMPORTANT: The Heat pump draws moisture from the air which then condenses into the
internal water tank. The unit will pause operation when the tank is full and will restart when
the tank has been emptied. It is recommended to use the heating mode in a room with 50%
humidity or lower. Avoid operating moisture-producing products or appliances such as a
humidifier or a kettle when using the unit in heating mode.
See the “Draining Water Condensation in Heat Mode” section for more information on draining
the water tank.
*Applicable for models with Heating feature only.
To Next Page
Loading...
Need help?
General
