Honeywell PRO TH2000DH Series - Wallplate Installation; Removing Thermostat from Wallplate; Mounting the Wallplate; Drilling Guidelines

Installation Guide
2
69-2609EFS—03
ENGLISH
M32805
Wallplate installation
Removethewallplatefromthethermostat
asshownatleft,thenfollowdirections
belowformounting.
1. Pullwiresthroughwirehole.
2. Positionwallplateonwall,levelandmarkhole
positions with pencil.
3. Drillholesatmarkedpositionsasshownbelow,
thentapinsuppliedwallanchors.
4. Placewallplateoveranchors,insertandtighten
mountingscrews.
Pullatbottomtoremovethermostat
fromwallplate.
CAUTION: ELECTRICAL HAZARD
Cancauseelectricalshockorequipmentdamage.Disconnectpowerbeforebeginning
installation.
Drill3/16"holesfordrywall.Drill7/32"holesforplaster.
MERCURY NOTICE
Ifthisproductisreplacingacontrolthatcontainsmercuryinasealedtube,donot
place the old control in the trash. Contact the Thermostat Recycling Corporation at
www.thermostat-recycle.orgor800-238-8192forinformationonhowandwhereto
properlyandsafelydisposeofyouroldthermostat.
M32731
TO REMOVE WALLPLATE
PULL HERE
Wallanchors
MountingscrewsWirehole