Honeywell PRO TH2000DH Series - Fan Settings and Thermostat Mounting; Fan Operation Switch Configuration; Attaching Thermostat to Wallplate; Managing Wires and Openings

PRO TH2000DH/TH1000DH Series
5
69-2609EFS—03
ENGLISH
W/
Aux
Not
Used
Heat Off Cool Auto On
Fan
M32705
W/
Aux
Not
Used
M32757
Heat Off Cool Auto On
Fan
TH2110DH/TH1110DH only:
• Gas or Oil:Forgasoroil
heatingsystems,leavethefan
operationswitchinthisfactory-
setposition.(Thissettingisfor
systemsthatcontrolthefanina
callforheat.)
• Electric or Heat Pump:Change
theswitchtothissettingforheat
pumporelectricheatsystems.
(Thissettingisforsystemsthat
allow the thermostat to control
thefaninacallforheat,ifa
fanwireisconnectedtotheG
terminal.)
Alignthe2tabsatthetopofthewall-
plate with corresponding slots on the
backofthethermostat,thenpushgen-
tlyuntilthethermostatsnapsinplace.
Thermostat mounting
Setfanoperationswitch.
Pushexcesswire
backintothewall
opening.
Plugwallopening
withnon-flammable
insulation.
Fan operation settings
XXXX
M32818
GAS OR OIL
ELECTRIC OR HEAT PUMP
GAS OR OIL
ELECTRIC OR HEAT PUMP