Honeywell Programmable Thermostat

PROGRAMMING YOUR THERMOSTAT
9
DAY
NOTE: The display shows
Programmed Recovery setting in
the following instructions.
If display reads SAT or SUN,
press and hold until MON TUE
WED THU FRI appears.
Press and hold until the display
shows the desired starting time.
Press and hold until the display
shows the desired temperature.
If the display starts to blink while
you are holding down
TEMPERATURE WARMER or
COOLER, you have reached the
setting limit. If your thermostat
can switch automatically between
heating and cooling, the heating
temperature must be at least 2
AHEAD
BACK
WARMER
COOLER
MON TUE WED THU FRI HEAT
WAKE
AM
SET
PT
MON TUE WED THU FRI HEAT
WAKE
AM
SET
PT
MON TUE WED THU FRI HEAT
WAKE
AM
SET
PT