Honeywell QuietClean HHT-215 series User Manual

QuietClean_OM.qxd 3/5/09 10:00 AM Pa 6
FILTER CLEAN INDICATORS HHT-215, HHT-217, HHT-219, HFD-110, HFD-112, HFD-015, HFD-116
This air purifier is equipped with an electronic filter clean monitor to serve as a convenient guideline for
cleaning the ifD™ Micro-filter and pre-filter based on the air purifier's hours of use and operating power
level. This is beneficial because a filter's life depends on the amount of air and contaminants drawn
through it. As you operate your QuietClean® Air Purifier, the filter clean monitor bar
will fill-up from left to right. The bar will continue to fill as you use the unit. Once
the bar is completely full, the Filter Reset button will illuminate — it is time to clean
the filters and reset the filter clean monitor.
Resetting the Filter Clean Monitor (HHT-215, HHT-217, HHT-219 Only)
After cleaning the ifD™ filter, you need to reset the filter clean monitor.
ə Once the ifD™ Micro-filter has been checked and cleaned, the filter clean
monitor will need to be reset.
¢ With the air purifier unit powered on, press and hold the Filter Reset button for
approximately 10 seconds or until the filter bar is clear (Fig. 9a} and LED light goes out.
Filter Clean Indicator Operation (HFD-015, HFD-110, HFD-112, HFD-116 Only)
+ When the filter clean indicator light illuminates, (Fig. 9b) it is time to inspect/clean 4 Die
the
ifD™
Micro-filter.
Ara
ə Once you have cleaned the filter, press and hold the Filter Reset button until the LED light goes out.
NOTE: Depending upon your individual usage (environment, hours and power level of operation), you may
need to check and clean the filters more or less frequently.
REMOVING / CLEANING THE IFD" MICRO-FILTER FOR ALL MODELS
To remove the ifD” Micro-filter:
ə Make certain that the air purifier is OFF and the unit is
unplugged.
* Push the Filter Release button and then gently lift the
filter assembly (Fig. 10a & 10b). The filter assembly will
only release if the button is pushed.
+ Remove the pre-filter (see “Cleaning the Pre-filter’),
and set aside.
To clean the ifD™ Micro-filter:
© (Optional) After removing the ifD™ Micro-filter from the air purifier, gently run
a vacuum cleaner with a nozzle or brush attachment along the filter to pick-up
tiny particles (Fig. 11}. Repeat on both sides.
if your ifD™ Micro-filter appears to have dirt that has not been removed by
vacuuming, or if you choose not to vacuum the filter first, please follow the steps
below to wash the ifD™ Micro-filter.
ə Turn the power off and unplug the air purifier.
* Remove the ifD” Micro-filter from the unit.
e You can simply rinse the ifD™ Micro-filter under the faucet, or for more thorough
cleaning, fill the sink with lukewarm water and add a few drops of mild dish
soap (Fig. 12).
e Gently swish the filter in the soap solution to clean.
ə Soak the filter for 2-3 minutes. Do not leave for an extended period of time.
e Rinse the filter with clean tap water.
e Shake the filter to remove any excess water,
* Place the filter with the honeycomb side down on a plush towel (Fig. 13).
i "a

Honeywell QuietClean HHT-215 series Specifications

General

Brand	Honeywell
Model	QuietClean HHT-215 series
Category	Air Cleaner
Language	English