Honeywell QuietClean HHT-215 series User Manual

QuietClean_OM.qxd 3/5/09 10:00 AM Pa 7
REMOVING / CLEANING THE IFD" MICRO-FILTER FOR ALL MODELS FILTER (continuen)
¢ Note that the filter may still be discolored even after washing.
This is acceptable and will not affect performance.
e Allow the ifD™ Micro-filter to dry for a few hours or overnight.
+ When the ifD™ Micro-filter is completely dry, place back into the air purifier.
Make sure you insert the filter according to the directional arrows on the filter.
CAUTION:
+ Never place a wet ifD™ Micro-filter in your air purifier.
» Do not use any solvents, strong cleaning agents or flammable liquids to clean the ifD™ Micro-filter.
CLEANING THE WASHABLE PRE-FILTER (ALL MODELS)
To remove the pre-filter:
Press the top tab to release the pre-filter from the filter
assembly (Fig. 14).
To clean the pre-filter:
The particle pre-filter helps pick-up large airborne particles
that enter the filter. The pre-filter can be removed and rinsed E
by hand under warm water (Fig. 15). Let the pre-filter dry
completely before inserting it back into the unit.
Some models are shipped with bonus odor control pre-filters that are not washable. After the pre-filters
have lost their odor reducing capability over time {approximately 3 months), you can order replacement
Odor-Lock™ pre-filters by calling the Kaz Consumer Relations Department at 1-800-477-0457.
INSTALLING THE ODOR-LOCK™ PRE-FILTER(S) (HFD-112, HHT-217 AND HHT-219 ONLY)
To replace the permanent, washable pre-filters with the
Odor-Lock™ pre-filters, remove the standard washable
pre-filter assembly by pushing on the top tab (Fig.16).
The pre-filter assembly has two pre-filters that will need
to be popped out of the pre-filter frame. Hold the frame
steady from the side while pushing in the center of each
pre-filter from the back side of the frame (Fig.17). This
will separate the pre-filter from the frame and you can
then pull it completely away from the frame (it will snap
out) (Fig.18}. Save the permanent washable pre-filters
as you may choose to use them in the future.*
To insert the Odor-Lock™ pre-filters into the pre-filter
frame, line the tabs on the pre-filter up with the frame
notches and snap into place (Fig.19).
Install the Odor-Lock™ filter assembly by inserting the
lower tab of the pre-filter frame into the filter assembly
untit you hear a “click” (Fig. 20).
Align the complete filter assembly with the opening in
the unit and insert back into the unit (Fig. 21).
NOTE: The Odor-Lock™ filters are not washable.
+

Honeywell QuietClean HHT-215 series Specifications

General

Brand	Honeywell
Model	QuietClean HHT-215 series
Category	Air Cleaner
Language	English