Honeywell RTH2310 - Page 15

RTH2310 Programmable Thermostat
To modify the schedule (cont'd)
While the time display is flashing, press i or
" to set the time (in increments of 15
minutes).
Press P#.
While the temperature display is flashing,
place the System switch on Heat and press
or to set the heat temperature. Place
the System switch on Cool and press or
to set the cool temperature.
Repeat steps 2 to 6 to set another period.
Press Exit.
n" Press to start programming
O or lo select another period
O Press lo select the days
Press lo set the time
or the temperature
Place on Heat when setting
~-~. the heal selpoint or on Cool
^—' when setting the cool setpoint
q Press to erase (skip) Ihe
displayed period
( ) Press to end programming
13