To prevent a short circuit from a loose wire –
When using multi-core cables: Only remove enough outer insulation to allow secure fixing of the cores into the terminal block.
When using single core cables: Secure them together with a cable tie as close as possible to the terminal block.
Power Up and Test
A) Power Up the Thermostat Remove the battery tab and clip the thermostat onto the wall plate.
B) Power Up the Heating System and do a quick functional test on the thermostat to check that it switches the boiler.
Configure the System
Specific settings for the thermostat and heating system can be configured in the advanced menu. Press and hold and then buttons
together until the display changes (approx. 3 seconds).
To Next Page
Loading...
