Need help?Do you have a question about the Honeywell T5+ and is the answer not in the manual?
General| Category | Thermostat |
|---|---|
| Connectivity | Wi-Fi |
| Display | Touchscreen |
| Energy Star Certified | Yes |
| Geofencing | Yes |
| Programmability | Yes |
| Humidification Control | No |
| Dehumidification Control | No |
| Remote Control | Yes, via app |
| Warranty | 1-Year Limited Warranty |
| Scheduling | 7-day programmable |
| App Control | Yes (Honeywell Home app) |
| Compatibility | Works with Amazon Alexa, Google Assistant, IFTTT |
Lists compatible heating, cooling, and heat pump systems.
Specifies the need for 24 VAC power and the C-wire adapter.
Turn off power at the breaker box and verify the system is off.
Detach the old thermostat from the wall plate, leaving wires attached.
Verify absence of 120/240V wires to ensure compatibility and safety.
Photograph the existing wiring for future reference during installation.
Identify and remove any jumpers connecting terminals before proceeding.
Record presence of wires in specific terminals like R, RH, Rc.
Document the color of wires connected to each terminal for accurate setup.
Check for a C-wire or use the adapter if needed for power.
Mount the UWP to the wall using screws and anchors.
Adjust the R-switch position (up or down) based on wiring notes.
Insert R-wire(s) into the appropriate R-terminal on the UWP.
To Next Page
