Honeywell T775U Series Installation Instructions

2. PROGRAMMING OUTPUTS (MOD AND RELAY) WITH NO RESET T775U SERIES 2000 CONTROLLER
27 62-0255–05
Fig. 63. Program - Action.
2.1.6. ACTION
1. From the menu, use the S and T buttons to high-
light ACTION.
Default: HEAT
2. Press the X button to display the action selections.
3. Use the S and T buttons to select the desired
value.
4. Press the X button to accept the highlighted selec-
tion and display the next option.
2.2. Program Next Output (Modulating Output or Relay)
For the next output, select the desired MOD or Relay from
the Program menu (see Fig. 57 on page 25).
Go to “2.1.2. SETPOINT” on page 25 to continue
programming.
When you finish programming the outputs, continue with
“1.3. Exit Programming without Reset”.
1.3. Exit Programming without Reset
Press the HOME button to leave programming mode and
return to the home screen.
This completes the programming procedure for
controllers that do not use Reset.
PROGRAM
MOD 1
ACTION
MENU
PROGRAM
MOD 1
ACTION
SELECT
ACTION
FOR
MOD 1
HEAT
COOL
REV ACT
DIR ACT
HUMID
DEHUMID
M24583

Honeywell T775U Series Specifications

General

Brand	Honeywell
Model	T775U Series
Category	Controller
Language	English