Honeywell TH3110D1008 User Manual

Installation
Instructions
Non-Programmable
Digital
Thermostat
PRO
3000 Series
TH3110D1008
TH3210D1004
Wallplate installation
PULL HERE
HIPS
M29389A
Remove the wallplate from the
thermostat by pulling from the
bottom, then follow directions below
for mounting.
1. Pull wires through wire hole.
2. Position wallplate on wall, level
and mark hole positions with
pencil.
3. Drill holes at marked positions as
shown below, then tap in supplied
wall anchors.
4. Place wallplate over anchors,
insert and tighten mounting
screws.
LEVEL HERE
LEVEL HERE
UP
MCR29390A
Drill 3/16”
holes for
drywall.
Wire hole
Read before installing
Mounting
screws
Drill 7/32”
holes for
plaster.

Honeywell TH3110D1008 Specifications

General

Model	TH3110D1008
Category	Thermostat
Display	Digital
Temperature Control Range	40°F to 90°F (4°C to 32°C)
Stages	1 Heat/1 Cool
Compatibility	Conventional systems
Accuracy	±1°F
Mounting	Horizontal
Changeover	Manual
Voltage	24VAC
Terminal Designations	R, W, Y, G

Summary

Installation Instructions

Wallplate Installation

Instructions for mounting the wallplate to the wall.

Power Options

Wiring Terminal Designations

Wiring Conventional and Heat Pump Systems

Wiring Notes

Important notes regarding wire specifications and terminal usage.

Fan Operation Settings (TH3110D only)

Thermostat Mounting

Installer Setup

Setup Functions and Settings

Details on configuring thermostat system type, cycle rates, and compressor settings.

Installer System Test

System Test Procedures

Procedures for testing heating, cooling, and emergency heat functions.

Troubleshooting

Display and System Response Issues

Resolving blank displays and system non-responsiveness.

Setting and Indicator Issues

Addressing issues with settings not changing and status indicators.

Specifications

Safety and Handling Precautions

Equipment and Electrical Hazards

Warnings for equipment damage and electrical shock risks.

Disposal Notices

Guidelines for proper disposal of mercury and electronic waste.