Honeywell TH8320ZW - Quick reference to controls; Quick reference to status display; Other display messages:; Clock setting

Your new thermostat is pre-programmed and ready to go. Just set the time and day.
Then check the settings below and change if needed:
1. Set clock ………………………….. See page 6
2. Select fan setting: Preset to Auto …………………………See page 7
3. Select system setting: Preset to Heat………………………..See page 8
3
Quick reference to controls
4
Quick reference to status display
Other display messages:
Cool On: Cooling system is activated
Heat On: Heating system is activated
Aux Heat On: Auxiliary heating system is activated
5
Clock setting
To set the current time display, press CLOCK, then press or to adjust
the time. Press and hold or to advance the time more quickly.
Press DONE to save & exit (or press CANCEL to exit without changing the time).