TH8320ZW1000
3
69-2486—03
M32429
Power Requirements
Wiring
Connect the common side of
the transformer to “C” terminal.
This connection is mandatory.
Remove tab.
The thermostat is shipped from the factory
with the coin cell installed. To keep the
battery from discharging during shipment
and storage, the thermostat is shipped
with a plastic tab inserted in the battery
holder. This tab must be removed dur-
ing installation. Simply pull the plastic tab
out of the battery tray. Make sure that the
battery tray is fully inserted into the ther-
mostat.
Push excess wire back into the wall opening. Plug
wall opening with non-flammable insulation.
Remove factory-installed jumper
only for two-transformer systems.
M32431
K
K
M32430
K
K
M32428
To Next Page
Loading...
