Doc ID - 1188 • Rev 04 4 / 8
To enable auto mode in other Honeywell 8000 models:
1. Access the thermostat, and then press System.
2. Press and hold the blank center button.
3. Press the up arrow until 0300 is displayed.
4. Change the value to 1, and then exit the menu.
To enable auto mode in the Honeywell 9000:
1. Access the thermostat, and then press MENU.
2. Browse to Advanced Preferences.
Preferences > Advanced Preferences
3. Press the Next button until the Heating and Cooling System Changeover
screen displays.
4. Press Automatic, and then press Done.
5. The Exit screen displays, press Yes to save your changes.
Configuring in Fusion
Once the thermostat has been installed, registered, and set to auto mode,
configure the Honeywell thermostat in Fusion.
To add the Honeywell WiFi device in Fusion:
1. Click the Devices tab, and then click the New Device button to display the
Select Template dialog.
2. Expand the Climate folder, and browse to the Honeywell WiFi Thermostats.
Climate > IP Thermostats > Honeywell WiFi Thermostats
To Next Page
Loading...
