M
michelesmithAug 10, 2025
What to do if the device is within range but still will not enroll on Honeywell Control Panel?
- HhaleysextonAug 10, 2025
If your device is within the proper range but still won't enroll with your Honeywell Control Panel, follow these steps: 1. On the Tuxedo Touch Keypad: * Press the Automation icon from the “Home” screen, then the Z-Wave Setup icon to display the “Z-Wave Device Management” screen. * If the device doesn't appear, press the Z-Wave Remove/Delete icon. 2. On the Z-Wave device, press the Function Key. The screen will display a “Device Removed” message. 3. On the Tuxedo Touch Keypad, enroll the device again.