Honeywell VisionPRO Series User Manual

39 69-2761EFS—03
Troubleshooting
If you have difficulty with your thermostat, try these suggestions. Most problems can
be corrected quickly and easily.
Screen is blank • Check circuit breaker and reset if necessary.
• Make sure power switch at heating and cooling system is on.
• Make sure furnace door is closed securely.
• If thermostat is battery powered, make sure fresh AA alkaline batteries are
installed correctly (see page 32).
Screen is
difficult to read
• Change screen brightness using Preferences menu (see page 26).
Red light is on • If thermostat is in Emergency Heat mode, the red light is normal. It shows
that the thermostat is in Emergency Heat mode.
• If thermostat is not in Emergency Heat mode, an alert is active. Check
message on the thermostat screen.
Heating or
cooling system
does not
respond
• Touch SYSTEM to set system to Heat. Make sure the temperature is set
higher than the Inside temperature.
• Touch SYSTEM to set system to Cool. Make sure the temperature is set
lower than the Inside temperature.
• Check circuit breaker and reset if necessary.
• Make sure power switch at heating & cooling system is on.
• Make sure furnace door is closed securely.
• If “Wait” is displayed, the compressor protection timer is on. Wait 5 minutes
for the system to restart safely, without damaging the compressor.

Honeywell VisionPRO Series Specifications

General

Programmable	Yes
Connectivity	Wi-Fi (some models)
Compatibility	Works with most HVAC systems
Operating Modes	Heat, Cool, Auto, Emergency Heat
Remote Access	Yes
Indoor Humidity Control	No
Backup Battery	Yes
Color Options	White