Honeywell VISTA-128BPTSIA - System Testing and Fire Safety; Setting the Time and Date

– 59 –
Setting the Time and Date
1. Enter Installer or Master Code + # + 63. Typical display shows:
TIME/DATE – THU
12:01 AM 01/01/10
The day of the week is automatically calculated based on the date entered. Time and date
entries are made by simply entering the appropriate hour, minute, month, day and year.
Press [∗] to move the cursor to the right of the display, to the next position.
Press [#] to move the cursor to the left of the display, to the previous position.
2. Enter the hour. Then press [∗] to move to the “minutes” field.
3. Enter the minutes. Press [∗] to move to the AM/PM position.
4. Press any key 0-9 to change AM to PM, or PM to AM. Press [∗] to move cursor to the
“month” field position.
5. Enter the month using a 2-digit entry. Press [∗] to move cursor to the “day” field position.
6. Enter the day using a 2-digit entry. Press [∗] to move cursor to the “year” field position.
7. Press [∗] to exit the real-time clock edit mode.